FREE SHIPPING ON ORDERS OVER NZ$200.

Login
0 Cart

Men's Jackets

Men's Baselayers

Men's Tops

Men's Pants & Shorts

Men's Accessories

Rab Cinder

After decades of riding the cutting edge of technology to keep you warm, dry, and protected in the toughest mountain conditions, we’ve created a collection of adventure cycling gear for when the road runs out.

Shop now

Womens Jackets

Women's Baselayers

Women's Tops

Women's Pants & Shorts

Women's Accessories

Rab Cinder

After decades of riding the cutting edge of technology to keep you warm, dry, and protected in the toughest mountain conditions, we’ve created a collection of adventure cycling gear for when the road runs out.

Shop now

Sleeping Bags

Backpacks

Shelters & Tents

Sleeping Pads

Spares & Repairs

Ski Equipment

Previous | Next
Red Paddle i-Fin - Original

Red Paddle i-Fin - Original

$14.95

This i-Fin is intended for board models with a thruster (3) fin set up.

Our i-Fin is designed to bend and flex which is a great advantage for a board that can be rolled up, transported or packed away.

The i-Fin can bend out of shape without this affecting the performance of the board and it should straighten itself gradually. If, however, you would like to straighten your i-Fins, watch our video on how to do so

This i-Fin is intended for board models with a thruster (3) fin set up.

Our i-Fin is designed to bend and flex which is a great advantage for a board that can be rolled up, transported or packed away.

The i-Fin can bend out of shape without this affecting the performance of the board and it should straighten itself gradually.

Sticking on an i-Fin:

Sticking an i-Fin to your board is simple. We recommend using any PVC boat repair glue or Henkle (Loctite) 401 which can be purchased widely online. Here are the gluing instructions we recommend following:

1) Inflate your board to 15 psi.
2) Clean the area to be glued - Ideally with some acetone.
3) Warm the fin with a hairdryer to make it more pliable (or leave them in the sun on a warm day)
4) Apply a layer of glue to both surfaces.
5) Now push the surfaces together making sure no air is trapped. You really need to push down hard onto the piece you are gluing. Pushing from the centre out to the edge. Ideally you need to push hard enough to squeeze a small amount of glue out of the edge of the piece you are gluing so using a metal spoon protect your thumbs and apply pressure is a good idea.
6) Keep applying force to the area to make sure all areas are well stuck down. You will need to work hard on the area for about 5 mins.
7) Ideally place a heavy weight on the area for 8 hrs.
8) Leave to dry for 24 hours before using.

Safety Note: We advise using protective wear such as gloves and goggles.

You may also like

Facebook

Instagram

Email

Search